Auto Controller Dse5210 Generator Genset Control Panel Module Control

DSE 5210 Genset Auto Controller

The DSE 5210 Genset Auto Controller designed to automatically start and stop diesel

and gas generating sets that include non electronic engines. The module also provides excellent engine monitoring and protection features.

The DSE 5210 Controller has the ability to monitor under speed, over speed, charge failure, emergency stop, low oil pressure, high engine temperature, fail to start, fail to stop, under/over generator volts,over current, under/over generator frequency, low/high DC battery volts, low fuel alarm and loss of the speed sensing signal. The module displays fault conditions on the LCD display and via the LED indicators on the front.

DSE Genset Controller DSE5210 include RS232 or RS485 communications capabilities for linking to a PC, sending SMS messages and interfacing with new and existing building management systems.

FEATURES of  Genset Controller DSE5210

• Automatic start
• Automatic load transfer
• Configurable inputs
• Configurable outputs
• Configurable alarms & timers
• Digital inputs
• Analogue inputs
• Back-lit character LCD display
• Engine protection
• Front panel mounting
• PC configurable
• Front panel programming
• Remote monitoring
• RS232or RS485 remote communications (to be specified on ordering)
• Modbus RTU
• Engine history event log
• LED alarm indication
• LCD alarm indication
• SMS messaging
• Hid till lit alarm icons
• Engine exercise mode
• Magnetic pick-up

BENEFITS

• Full integration into new and existing building management systems
• In-built engine diagnostics removes the requirement for service equipment
• License free PC software
• Modules help to improve the life cycle of engine starter motors
• On-site module configuration to match user requirements
• Remote module configuration using PC software
• Modules send SMS messages to engineers to notify specific engine problems (GSM Modem and SIM Card required)
• User-friendly set-up and button layout

OPERATION

DSE5210 is operated using the front STOP, AUTO and MANUAL push buttons.

CONFIGURATION

The modules can be configured using the front panel buttons or by using the DSE810 interface and PC software.

DSE5210 Auto Controller

Generator Volts L1-N, L2-N, L3-N

Generator Volts L1-L2, L2-L3, L3-L1

Generator Amps L1,L2,L3

Generator Frequency Hz

Engine Speed RPM

Engine Oil Pressure

Fuel Level %

Engine Temperature

Plant Battery Volts

Engine Hours Run

Generator kVA

Generator Kw

Generator Cosθ

PC Software

DSE5210 Auto Start Generator Controller has the ability to be controlled, configured and monitored from a remote PC, using the DSE810 interface.

Application: >10 KW gas & diesel generator started with battery